Author Topic: mod_productscroller marquee help  (Read 2440 times)

aaron1988

  • Beginner
  • *
  • Posts: 20
mod_productscroller marquee help
« on: December 31, 2009, 20:29:41 pm »
Hi was wondering if someone help mke in the module productscroller it has code <marquee behavior how can i change this so when i run it through a validator so it VALIDATES please, as in a validator the marquee tag has never been able to validate please help

Regards,
Aaron

Fisch.666

  • Beginner
  • *
  • Posts: 1
Re: mod_productscroller marquee help
« Reply #1 on: July 30, 2010, 07:59:08 am »
Hi!

Any news on this?

Are there any chances to make the code of the productscroller xhtml conform? When i check my page with the validator from http://validator.w3.org i get invalid messages like this:

Code: [Select]
there is no attribute "behavior"

               <marquee behavior="scroll"

You have used the attribute named above in your document, but the document type you are using does not support that attribute for this element. This error is often caused by incorrect use of the "Strict" document type with a document that uses frames (e.g. you must use the "Transitional" document type to get the "target" attribute), or by using vendor proprietary extensions such as "marginheight" (this is usually fixed by using CSS to achieve the desired effect instead).

This error may also result if the element itself is not supported in the document type you are using, as an undefined element will have no supported attributes; in this case, see the element-undefined error message for further information.

How to fix: check the spelling and case of the element and attribute, (Remember XHTML is all lower-case) and/or check that they are both allowed in the chosen document type, and/or use CSS instead of this attribute. If you received this error when using the <embed> element to incorporate flash media in a Web page, see the FAQ item on valid flash.

Thanks in advance for a reply